Here are most of my normal prices these are based on the time taken on each job.

Price List

Theses prices do not cover parts and accessories.

Times given are estimates only times may change prices won’t.

Bikes that can’t be fixed onsite will be taken away to our workshop and brought back to you.

Suspension forks and rear suspension will be quoted for be for work taken place

Details of servicing

 Safety Check - £15.00

• Check cycle for any damage
• Check condition of cycle including chain wear
• Check wheel nuts / skewers are tight
• Check wheels are true and cones are set correctly
• Check rim for damage and sign’s of wear
• Check condition of tyres and inflate tubes
• Check pedals, cranks and b/b are tight
• Check headset is adjusted properly
• Set handlebars and stem to preferred position
• Remove seat post, clean, grease and refit
• Set saddle level and in alignment
• Check brake function *
• Check gear function *
• Road test cycle

*New cables will be used if needed not included in the price

Full Service - £35.00

• Front and rear Brake service
• Front and rear Gear service
• Check tyres and inflate tubes
• Check pedals are tight
• Check cranks and b/b are tight
• Check wheel nuts/skewers are tight
• Adjust cones front and rear, dismantle if necessary
• Check wheels are true **
• Check rims for wear
• Check headset is adjusted properly
• Set handlebars and stem to preferred position
• Correctly adjust handlebar controls
• Remove seat post, clean, grease and refit
• Set saddle level and in alignment
• Check all mudguards, carriers, etc are tight and correctly fitted
• Adjust and size cycle to customer
• Road test cycle

*New cables will be used if needed not included in the price

**Additional charge if wheels are severely buckled

Brake Service - £6.00 each end

• Set lever to correct position on handlebars
• Adjust lever for reach
• Adjust pitch of lever relative to sitting position
• Lubricate lever pivot points
• Check cable alignment through ferrule
• Remove inner wire, steel wool, and then grease cable
• Trim outer casing ends and replace caps as necessary
• Trim inner wire to correct length and re-crimp
• Remove callipers from frame/forks
• Clean and lubricate all components of callipers
• Dress surface of brake blocks
• Adjust spring tension
• Re assemble callipers and connect cables
• Adjust brake to cycle
• Slight truing of wheels if necessary
• Fine tune brake

*New cables will be used if needed not included in the price

Gear Service - £6.00 each end

• Check system for reported faults
• Check operation on stand
• Measure chain wear and check length
• Check pulley wheels for wear
• Check lever, adjust and lubricate as necessary
• Remove inner wires, grease and replace*
• Check condition of outers and trim as necessary
• Replace end caps
• Check dropout alignment
• Set limit stop screws on rear mech
• Adjust cable tension
• Align front mech and adjust for height
• Set limit stop screws on front mech
• Adjust cable tension
• Fine-tune both mechanisms’ operation

*New cables will be used if needed not included in the price